Why does a pipe split when it freezes?
Water expands as it turns to ice, and a pipe that is full of ice has nowhere for that expansion to go, so it splits at the weakest point.
A pipe that freezes is not always split at the moment it freezes. The ice can block the flow for a while, and pressure builds behind the blockage. When the ice finally begins to melt, the water that was stuck behind it is released in a sudden surge, and the split may not be visible until then.
The split can be small or large. A hairline crack can leak slowly for hours and go unnoticed until a stain appears on a ceiling or a floor begins to feel soft. A full split can release the supply in minutes. Either kind needs the water shut off, because the leak will continue until the flow is stopped.
Which parts of a house freeze first?
Unheated and poorly insulated spaces, such as crawl spaces, garages, attics, exterior walls and utility closets, because the cold reaches the pipe before it reaches the living space.
A pipe along an exterior wall with little insulation is closer to the outside air than one in a central wall. When the outside temperature drops and the wall has no heat behind it, the pipe can reach its freezing point while the rest of the house stays warm. The same is true of pipes in a garage or in a crawl space that is not sealed.
Attics and the spaces around the water heater and the washing machine are also common trouble spots. A pipe that runs through a cold attic or a gap in the framing can freeze in a cold snap even when the house is comfortable. The homeowner can see many of these locations from inside, and the crew can point out the rest after a split.
What does a crew check after a burst line?
The crew checks the water path, the materials it reached, the condition of the framing and the cavities, and whether the split is the only break or part of a line that failed in several places.
The path is traced from the split to the lowest point the water reached. That tells the crew which walls, floors and cavities hold water and which materials need to come out. The crew also checks the framing for swelling and the subfloor for softness, because water that sits under a floor can weaken the wood even after it is dry.
A thaw can reveal more than one split. A line that froze in several places may have a second break that has not yet leaked, and the crew notes any sign of one. The homeowner is told what was found, so a plumber can check the whole run instead of only the first split.
How is the water shut off, and what should the homeowner do first?
Close the main or the nearest local valve, then open the affected faucets to drain the line, and keep the power away from any wet area until the crew arrives.
The main shutoff is usually near where the water line enters the house, and a local valve may be near the fixture or under a sink. Turning the valve clockwise stops the flow, and opening the faucet afterward lets the remaining water drain. The homeowner should know where the main is before a freeze, because searching during a leak wastes time.
Once the water is off, the homeowner can move furniture and valuables out of the affected room, lay towels or buckets at the source and keep the room closed off. Power to the wet area should be shut off at the panel if it can be reached without standing in water, and the crew will take over from there.
Why does drying matter more after a freeze than after a leak at room temperature?
A cold event can soak materials and cavities that stay cool for longer, which slows evaporation, so the drying needs more time and more equipment to reach the target.
Water that spreads into a cold wall or floor is slower to evaporate than water in a warm room. The cavity and the framing stay cool, and the moisture moves more slowly through them. The crew adjusts the equipment and the time for that, and it watches the readings closely so the drying does not stall short of the target.
The cold also makes the house harder to heat while the drying runs. The crew will ask the homeowner to keep the heat on in the affected rooms as far as the power and the equipment allow, because a warmer room dries faster and the air holds more moisture that the dehumidifiers can remove.