Phones answered 24/7Kettering, OH
Call (833) 490-5225
(833) 490-5225
Guide

Frozen and burst pipes in an Ohio winter

Why pipes freeze in unheated spaces during Ohio winters, what to do in the first minutes, and how to thaw a line without starting a second leak.

Illustration for the guide "Frozen and burst pipes in an Ohio winter" (Kettering, OH)
Short answer

Pipes freeze where cold air reaches them: crawl spaces, exterior walls, garages and attics. A freeze becomes a burst when the water inside expands and splits the pipe, and the leak often shows only after the thaw. Open a faucet, shut the main if anything leaks, and call before you try to thaw a line with an open flame.

Key takeaways

  • Pipes freeze in cold spaces such as exterior walls, crawl spaces, garages and attics where insulation is thin.
  • A burst often shows up only after the line thaws, so a dry floor on a cold morning is not proof that the pipe is sound.
  • Open the faucet on the frozen line, and shut the main if a leak starts, before any thawing begins.
  • Use gentle, indirect heat to thaw a line, and never use an open flame near a pipe or a wall.
  • Thawing from the faucet end lets melting water escape, which lowers the pressure that splits a pipe.
  • Water that has soaked into a wall or crawl space needs a drying plan, not just a mop.

Why do pipes freeze in Ohio homes?

Water expands as it freezes, and a pipe full of it can split. Freezing starts where the air is coldest: exterior walls, unheated crawl spaces, garages, attics and any line that runs along a cold corner of the house.

Ohio winters bring long cold spells as well as short hard freezes, and a cold snap can last long enough for the air around a pipe to drop below freezing even indoors. Pipes in exterior walls are the most exposed, because the wall has less insulation and sometimes a gap that lets cold air in.

Crawl spaces and garages are common trouble spots. A crawl space has air moving through it that is close to the outside temperature, and a supply line that runs along the floor joists can freeze before anyone notices. An unheated garage can hold a water heater line or an outdoor hose bib that freezes overnight.

Snow adds to the risk. Drifts can bury a foundation vent, and a blocked vent lets the crawl space cool, which can freeze lines that were safe the week before. Clearing snow from vents and access points is one of the cheapest winter steps a homeowner can take.

Pipes that run through an attic, a garage ceiling or a cold porch deserve the same attention as those in exterior walls. Look for lines close to a vent, a window that does not seal or a door to an unheated room, since those are the paths that let the cold reach the water inside.

What should you do first when a pipe freezes?

Find the frozen section, open the nearest faucet to relieve pressure and shut the main if the line is already leaking. Then choose a safe way to thaw it.

A frozen line may have no water coming out at all. Open the faucet at the far end of the line so that melting water has somewhere to go. An open faucet relieves pressure, and pressure is what splits a pipe during a thaw.

If there is any sign of a crack, a drip or a bulge, shut off the main water supply before doing anything else. Knowing where the main is before winter arrives is the step that keeps a burst from becoming a flooded room.

Keep the thaw safe. Use warm air from a hair dryer or a space heater placed well away from the pipe and from anything flammable. Do not use an open flame, a torch or a propane heater on a pipe. If you cannot reach the frozen section, or the line runs inside a wall, call for help.

Keep the fixtures near a leak closed until the readings show the room is drying. Running a faucet to test it adds water to a wall that is already holding more than it can release, and the extra water lengthens the drying time.

How can you thaw a line without starting a leak?

Thaw slowly with gentle, indirect heat, starting at the faucet end and working back toward the frozen section. Rapid heat can crack a pipe that is already weak, and a fast thaw can push water through an opening that has formed.

Warm the air around the pipe rather than the pipe itself. Towels wrapped around the line and warmed, or a space heater aimed at the section from a safe distance, are slower but less likely to damage the pipe. Check the line every few minutes for dripping water or new cracks.

Watch for water. If a joint begins to drip during the thaw, shut the main and stop. A drip means the line may have split, and the pressure will push water out when service returns, so the leak should be found before the supply is restored.

Do not thaw a pipe with a heater that is not rated for the job, and never leave a heater running unattended near a wall. If the line runs through a wall, a crawl space or an attic where you cannot see it, a qualified person should check it rather than guessing at the spot.

Stop if the line makes a loud or sharp noise during the thaw, or if the pipe bulges. Those are signs the metal or plastic is under strain. Shut the water off, let the line cool and call for an inspection rather than forcing the thaw to finish.

If the thaw succeeds, still check the line for an hour. Look at every joint and fitting you can reach, and watch the spot where the cold was. A joint that stays dry for an hour under normal pressure is much more likely to stay dry than one that is checked only once.

What does a burst pipe leave behind?

A burst can soak insulation, drywall, the subfloor and the framing behind a wall, and the damage often shows up as a stain or a soft floor a day later. Treat the wet area as a drying job from the start.

When a pipe bursts inside a wall, water runs down the cavity and collects at the lowest point, which may be a floor several feet from the break. The first sign can be a bulge in the drywall, a damp spot on the floor or a musty smell a day later.

Winter bursts also tend to release a lot of water quickly once the line is restored, because the pressure that the freeze held back is suddenly available. A room that was dry at night can be wet by morning, which is why shutting the main before the thaw matters so much.

Call for water removal and drying as soon as the leak is found. Ask for dated photographs, moisture readings and a removal list, and keep a record of the time the line was shut off and the temperature when it froze. Those details help an insurer understand when the freeze started and what happened next.

Consider a leak sensor near the water heater and any appliance on a lower floor. A small sensor that sounds an alarm can catch a slow leak that starts while the house is empty during a cold week, when the first sign would otherwise be a stain.

What can a homeowner do before the cold arrives?

Before winter, insulate the lines that run through cold spaces, seal the gaps where cold air enters, clear the vents and locate the main shutoff. Each step is quick, and each is easier in the fall than in the middle of a cold night.

Insulate exposed pipes in crawl spaces, garages and exterior walls. Foam sleeves are a common choice for lines that run along the floor joists. Seal gaps where pipes pass through the rim joist, since that is where cold air often enters a crawl space or basement.

Disconnect garden hoses from the outdoor faucets before the first hard freeze, and close the interior valve to any outdoor faucet if the house has one. Drain the outdoor line after shutting it off, so water left in the pipe cannot freeze and split it.

Find the main shutoff and the shutoff for any unheated area. Test each valve once in the fall to make sure it turns, since a valve that has been stuck for years is the one that fails when a burst needs it most.

Review the plan after every cold snap. Note which room was coldest, which pipe was most exposed and whether the insulation or the vent cover did its job. A yearly review, timed for the first hard freeze, is enough for most households.

How does a frozen-pipe event fit into a winter plan?

A winter plan keeps the heat on in every room with plumbing, makes the main shutoff easy to find and includes a number to call for water removal. It should also say who checks on the house if the household is away during a cold spell.

Keep the heat on at a steady temperature even when the house is empty. A house set to a very low temperature can lose warmth in its walls and crawl space, and that is when the lines freeze. If you travel, ask someone to check the house during a cold stretch, and make sure they know where the main shutoff is.

Keep a short written list that covers the main shutoff, the utility panel, the shutoff for any unheated area and the number to call. Tape it inside a utility closet where anyone in the house can find it at night.

If a freeze happens, call (833) 490-5225 at any hour. Someone picks up and takes the details of the event, including the temperature, where the pipe froze and whether water is still moving. The first safety steps come first, and a crew is sent after the call.

Frequently asked questions

Can I pour hot water on a frozen pipe?

Warm water can help if the line is accessible and the water is not hot enough to crack a fitting, but slow, indirect heat is the safer choice. Open the faucet first so the melting water can drain.

Will a faucet dripping slightly prevent freezing?

It can keep water moving in a line, which helps during very cold spells, but it does not protect lines in an unheated space if the cold is severe. Combine it with insulation and heat to the space.

Why does a pipe that thawed still leak later?

A pipe can crack when it freezes and only leak once the water is back under pressure. Shut the main and check the line before turning it fully on, and call for help if a joint drips.

Does a frozen pipe always mean a burst?

No, but it is a warning. A freeze that thawed without damage still deserves an inspection of the line, the insulation and the spot where cold got in, so the next freeze can be prevented.

This guide is general information for Montgomery County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

One call and it gets handled.

A crew is dispatched as fast as one is available, and you approve the estimate before any work starts.

Keep reading

More guides

What to check when the Great Miami is running high

When the Great Miami is high, the valley's dams and floodgates may be working, parks and roads may close, and the house has to be checked from the outside before water reaches the basement.

WhatsApp